This Reflector pYSF3 by Antonio IU5JAE is part of the Sardinia Multiprotocol network, it is connected with IT C4FM Italy (YCS222) DG-ID 89, the TG22289 DMR BrandMeister and the E module of the Reflector M17-IS0 for the M17 protocol, get the data flow from HBlink, thanks to the link with HBlink BrandMeister.
BrandMeister also provides the link to Wires-X Room #41686 IT-IS0-ERA-CA.

QSO traffic

# Status Call Gateway Description Radio Serial Target GID Stream Data_type Call_mode Frame Deviation UTC_Time(QSO) Map
# QSO progressive number
Status TX=Transmission in progress (green) TC=Complete Transmission (white) TD=DG-ID change/Stream (light blue) TB=Transmission blocked (grey)
(invalid callsign, invalid suffix, etc.)
TO=TX time out (pink)
WD=TX with corrupted packets (yellow)
Call Callsign
Gateway Entry from the node
Description Link name
Radio Radio model used Source stream
Serial Serial assigned to the radio/system
GID DG-ID used
Stream Stream identifier
Data_type V/D mode 1 (simultaneous voice/data type 1) V/D mode 2 (simultaneous voice/data type 2) Data FR (high-speed data TX) Voice FR (high-quality voice full rate)  
Call_mode Group/CQ Radio ID Individual
Frame Shows the frame number
Deviation Wide Narrow
UTC_Time(QSO) In TX that's when it started End TX is when it's finished (duration)
Map TX contains GPS data displays location
DG-ID Assigned
DG-ID configured: 01=Local Repeater
It allows you to make the QSO exclusively on your repeater in use
09=Local Reflector
Allows QSOs to be made exclusively in this Reflector
89=Cluster E.R.A.
Linked with DMR TG22289/BM

Repeaters, hotspots and bridges linked

# Call DG-ID_(Description) Gateway_IP Refl_outgoing_port 0/60 Connected_from Muted Locked Status Back_to_home BTH_in_secs Activated_secs Missing_secs
# QSO progressive number
Call Callsign
DG-ID_(Description) DG-ID used
Gateway_IP IP number
Refl_outgoing_port Port UDP used
0/60 Quality link
Connected_from Connected since
Muted yes no
Locked yes no
Status Fixed (It is not allowed to change DG-ID) Movable (It is allowed to change DG-ID)
Back_to_home Unset (No configuration to return to the default DG-ID) Number (DG-ID configured to return after BTH time)
BTH_in_secs Time set for returning to the default DG-ID after the change
Activated_secs Remaining time to return to the default DG-ID after the change
Missing_secs Elapsed time after DG-ID change

Callsigns blocked in time

# Call Blocked at (local) Reason Released (server time)
# QSO progressive number
Call Callsign
Blocked at (local) Time when it was blocked
Reason Indicates the reason for the block
Released Time required for recovery